Code Sample Download


C Measurement Library

WLAN_Meas_Lib_C_Ex09 -

This example demonstrates the use of the WLAN Measurement Library
DLL interface in Microsoft Visual C++ V6.0 to perform measurements
on a 802.11n 40MHz bandwidth signal:

    • Assign digitizer by resource strings
    • Set measurement parameters
    • Enable required measurements
    • Power Profile
        Average Power


        Peak Power


        Burst Length


        Rising Edge Time


        Falling Edge Time
      Modulation Accuracy
        System Type


        Modulation Type


        Data Rate


        HT Format


        HT MCS


        EVM RMS


        EVM Data Carriers


        EVM Pilot Carriers


        RCE RMS


        RCE Data Carriers


        RCE Pilot Carriers


        Frequency Error


        Symbol Clock Error


        Carrier Leak


        IQ Gain Imbalance


        IQ Skew


        Number of PSDU Bits


        Number of PSDU Symbols
      Spectral Flatness




  • Make measurements
  • Retrieve measurement results

A DUT or signal generator will need to be generating
802.11n (40MHz bandwidth) RF bursts as follows:-
RF Frequency....: 2000MHz

It assumes that the following has been installed successfully:

Aeroflex 3011 RF Synthesizer PXI module
Aeroflex 303xC RF Digitizer PXI module

Aeroflex PXI Module Software - V6.9.0 or better
Aeroflex WLAN Measurement Suite - V2.0.0 or better

It is also assumed that:

The 3010 LO output is connected to the 3030 LO input
The 303x IF output is connected to the 303x IF input (if applicable)


Disclaimer of Warranty

This example code is provided 'as is' without warranty.

Neither Aeroflex nor the author(s) warrant that the functions of the software will meet your requirements or that the media is compatible with any computer system on which it is used or that operation of the software will be unlimited or error free. You assume responsibility for selecting the software to achieve your intended results and for the installation of, the use of and the results obtained from the software. In no event shall Aeroflex or its suppliers be liable for any damages whatsoever arising out of installation of the software or incompatibility with any computer system or technical limitation of the software or use or inability to use the software, even if advised of the possibility of such damages. Neither Aeroflex nor the author(s) will be liable for any loss or damage of any nature suffered by any party as a result of reliance upon or reproduction of or any errors in any contents of the software.

Back to top